REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) AS THERE ARE NO USER-SERVICEABLE PARTS INSIDE.
Consult the dealer or an experienced radio/TV technician for help. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference,and (2)this device must accept any interference received,including interference that may cause undesired operation.Ĭhanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. For MXP124 and MXP124FX, the peak inrush current is 0.48A. * MXP124 and MXP124FX can be used in following electromagnetic environment: residential, commercial and light industrial, urban outdoors. Getting the PC audio its own track isn't vital, but I'll do that if I'm able. 
My hope is for my mic and the phone to record on separate tracks if possible, yes. I am using my phone through a separate channel on the board from the mic. So the audio device is listed as "USB Audio Device." So I have a USB line in/headphone splitter to run the mixer to the PC. My mixer does not have USB output, nor does my PC have a line in jack. Just to be clear, your using something like skype with headphones and a mic and want to be able to put the mic on one track, the audio from the person calling on another track, and also record anything played back on the computer separately, to be edited later. Without some kind of interface you will only get up to two channels and those will be set to left and right (as far as I know). I am a bit confused, why and how are you sending the PC audio through the mixer, and how are you interfacing with the USB as the mixer (at least the one I saw) does not look like it has a usb output.
0 kommentar(er)
